Stiebel Eltron Wall Mounted Cylinder 30, 50, 100 & 150ltrs

Stiebel Eltron Wall Mounted Cylinder 30, 50, 100 & 150ltrs

All Stiebel SHZ electronic water heaters in this range have a dual circuit that can be used for single phase supplies from 1kW up to 4kW.

Therefore ideal if the power supply available is as low as 1000W (1kW). For domestic electrical supplies the unit can be connected to loads of 1, 2, 3 and 4kW, with varying flow and recovery rates.

However this water heater can also be connected to a 3 phase supply if required. If a three phase supply is chosen then each phase requires 3 to 6kW.

All accessories are supplied with the SHZ range for a quick and easy installation. This water heater does not rely on gravity and can be installed over / under-sink or any cupboard space available. Minimum inlet water pressure required, 0.6 Bar.

The water inlet and supply connections are from the underside and requires just 50mm (2") clearance. Because the top of this water heater does not require any clearance at all, it is therefore ideal for limited space installations!

Electronic temperature control selection: +35C ~ +82C, ideal for multiple draw off points with low standby power consumption. This water heater does not rely on gravity and can be installed over / under-sink or any cupboard space.

• Infinitely variable temperature selection from 35 °C to 70 °C
• Suitable safety valve included in standard delivery
• Electronic heat content indication via LED in the user interface
• High-grade thermal insulation with the lowest heat losses
• Maintenance free impressed current anode
• Radiator connections through complete flanged plug
• Temperature settings include, frost protection and energy saving
• Steel inner cylinder, enamel coated with protection anode
• Before installing ensure wall has sufficient load bearing capacity
• CFC free thermal insulation
• 24hr low stand-by power consumption @ 65C!
• Suitable for multiple draw-off points
• Minimum inlet water pressure required, 0.6 Bar
• Electronic heat content display
• IP Rating: IP24
• LED user interface
• 60C (economy setting)

Single phase: Choice of connected loads: 1, 2, 3, or 4kW

Three phase: Connected loads: 3 - 6kW per phase