Prestige Low Surface Temperature Towel Warmer Curved Chrome

Pre-set Surface Temperature of Approximately 43C

The Prestige Chrome Curved Low Surface Temperature towel radiators have been independently tested and certified to meet the NHS guidance of safe surface temperatures for use in care homes, hospitals, rented accommodation or anywhere that the general public may come in to contact with a heated towel radiator. On the control panel the Blue LED lights up to indicate the current (ON) status of the element. The element will automatically turn itself off until the temperature drops below 43C, and will continue to operate thermostatically.

The 43D element has a timer function button, this will activate the 2 hour timer function and automatically turns itself off after 2 hours. The timer mode is indicated with a Red LED light. Pressing the timer mode again will deactivate the timer function and revert back to the standard heating mode Blue LED.

The towel radiator also has an antifreeze function, as long as the element is connected to the mains supply the temperature sensor will continue to control heating at medium temperature. This means that the antifreeze function remains active when the heater is turned off. As soon as the temperature around the sensor drops below 6ºC the element will switch itself on and prevent the radiator from freezing! In the event of a total power failure, this LST radiator is pre-filled with an antifreeze solution.

• See downloads for Prestige Low Surface Temperature Certifications!
• Independently tested and certified to meet the NHS guidance of safe surface temperatures
• Ideal for care homes or where low surface temperatures are essential
• Can be controlled via the Towel Radiator Thermostatic Control Plate TCP200
• Stylish low surface temperature thermostatic element pre-set to 43C!
• The heating element cannot be tampered with its either on or off!
• Antifreeze function protects against radiator temperature falling below 6ºC
• Element can be left switched on permanently @ low cost heating!
• Available widths: 400, 450, 500 & 600 mm
• Available heights: 600, 800, 1000, 1200, 1400, 1600 & 1800 mm
• Low standby power consumption
• Double overheating protection
• IPX5 suitable for zone one bathrooms
• 2 hour timer function
• Colour match power cable
• Outputs: 200W, 300W, 400W, 600W and 800W
• ½” BSP element fittings
• Pre-filled with an antifreeze solution
• Projection from wall: 65mm - 88mm (adjustable)