Apply for a Trade Account Here

Handyflow Oversink Vented Water Heater 5 Litres

£112.80 £94.00
In stock
Delivery Time:
Next Working Day
Warranty:
1 Year
Quick Code:
12264
Order Line:
01977 663331
  • Temperature range: 35C 80C
  • White corrosion proof case
  • Suitable for single outlets only
  • W270mm: D180mm: H400mm

Handyflow Oversink Vented Water Heater 5 Litres.

Ideal Ideal for occasional use light dish washing at a single kitchen sink in the workplace, for example portable buildings, offices, shops, workshops, garages and other small commercial premises that have limited power supplies available!


The Handy-flow Slimline design incorporates a thermal cut-out that can be re-set rather than requiring to be replaced. This feature is particularly useful when the heater is likely to be drained frequently (e.g. when fitted in Port-a-cabins). The Handy-flow is a simple to install traditional vented over-sink water heater. Suitable for hand-wash basins or small sinks. 

  • Open outlet heater to supply hot water to a single sink
  • Ideal when economy and ease of installation are the key priorities
  • Stylish design and slimline profile – depth only 7” (180mm)
  • Comes complete with tap and chrome spout
  • Thermal cut-out can be re-set rather than requiring to be replaced
  • 2.0 kW element
  • External temperature control with frost protection setting
  • Neon element on indicator
  • Wall fixing bracket included and cable pre-wired (1m) – saves time on installation
  • No need for expansion vessel, relief valve or reducing valve
  • Effective, practical solution wherever time and simplicity are the key priorities
  • External temperature control
  • Spout length: 230mm
  • Spout projection:150mm
  • 2kW element
  • Fuse: 13 amp / 240V / 50Hz
  • Temperature range: 35C 80C
  • White corrosion proof case
  • CFC free polyurethane insulation
  • Suitable for single outlets only
  • W270mm: D180mm: H400mm
  • IP Rating: IP24

 

Installation:
Must be sited above a sink using the wall fixing bracket supplied, with the spout and tap located at the bottom of the unit.

Plumbing:
Must be installed by a suitably qualified person.

Minimum water pressure 0.3 bar.
Maximum water pressure 8.0 bar.

Water Connection:
Inlet valve/tap 1 x 15mm compression.
Outlet 1 x chrome plated brass spray arm. 
Fittings required (not supplied): none.

ONLY USE THE FITTINGS SUPPLIED SO THAT THE UNIT IS NOT PRESSURISED.

Electrical Connection:
Installation must comply with current IEE regulations.

The product should be connected to the fixed wiring of the property via a double pole fused spur with a minimum break capacity of 13 amps.

Cable pre-wired (1m).

We found other products you might like!